Please Sign In

New To Sportsman Network?

My first band. Shot in clinton came from tennessee

November 27, 2013 at 8:11pm

I just found out that my paw in law is going on a turkey hunt this weekend somewhere out of state...I thought he might have meant duck huntin. I'm no big time turkey hunter but I do know we only have a spring season but come to find out many states have a spring and fall season. Why don't we?

November 22, 2013 at 1:55pm

Had a blast

November 12, 2013 at 1:41pm

Squirrel huntin sunday i went to check my duck spots

October 28, 2013 at 7:48am

All in a days work!

September 29, 2013 at 3:30pm

I took my dad fishig for father day. We launched out of he Riolets. One of the stops all the way down the ICW aroud Michould. When we went to leave motor did not start. Sounded like starter draggin. Popped cowling and starter housing was cracked as if someone pried on it. Read my letter and give me some opinions where to go next if the Company does not respond.

To whom it may concern,
My name is Thomas A. Mcwillie and some time during September 2012 I dropped a 2003 Stratos boat off to you for an engine diagnosis. The diagnosis was a bad swivel bracket and EMM. So I ok'd the parts to be repaired. Here lies the problem. My problem is with the integrity of the work done by the mechanic. I take my boat to-(A very reputable and popular boat sales and repair place, which I will not disclose at this time) because I thought highly of your mechanics, but not so much anymore. First of all, when I went to pick up my boat the first thing I noticed right off the bat, should have been obvious, was that the motor was mounted on the boat crooked. That should never happen at a reputable company like yours, that sounds more like a backwoods, working out of a garage type of mechanic work. Second, when my boat was dropped off all my guages worked with out flaw, so when I noticed that my trim guage did not work anymore, I brought it to the attention of the mechanic (Blank) and he told me that my guage went bad. That is quite coincidence considering he had to do work to on the swivel bracket which houses the sensor for the tilt guage. This bring me to problem number three, while on the water with my dad for Fathers Day 2013, the starter on my motor would not get the motor running. It sounded like the starter was dragging. No problem, starters go out, it happens. I thought I would take the motor cover off, and see if I could diagnose the problem because I did not want to have to call 'SeaTow' while 17 miles from the boat launch. When I took the cowling off I was very disappointed to see that the whole starter housing had been cracked. Now I know the mechanic had to do work around the cracked area because he had to hoist the motor to change the swivel bracket, and this is also the area he had to work on to change my EMM. Go figure, another coincidence, something your mechanic worked with was broke. I can't say for sure that your mechanic broke it, because I never removed the cowling until the other day when the motor failed to start but I can find no other reason for the housing to all of a sudden just break. Why it took so long to stop working, I'll blame that on rough water, or transporting the boat on Louisiana roads, but I do know that it was not broke before I took it to 'BLANK'. Last but not least another problem with the integrity of the mechanic work. The main reason my boat was brought to 'BLANK' was because the motor would not stay running. I was told that the computer is water cooled and that a thermocoupling went bad and fried the EMM. When I pulled the cowling off I was amazed to see the waterline going to the EMM was not fastened to the computer in any way and was actually leaking water. Good thing it never actually came all the way off and fry another $1,218.93 computer.
So all in all I paid $2,500.09 just to have more problems.
Any help would be greatly appretiated.

June 17, 2013 at 10:55am

Took the old man fishing. Launched at rigolets, fish everywhere. Rigs in Borgne, Michould, ICW, Trestles. Had to stretch a few but had a great day with my Dad.

June 17, 2013 at 10:32am

Hey Mr. Holmes,or anyone at that, are the locks open? Someone asked a while back but there was no response. Anyone?

June 14, 2013 at 11:31pm

Have they opened the locks yet?

April 04, 2013 at 9:24pm

Would anyone tell me if people run the canal that parallels I55. Preferably all the way north and south. I usually stay on the tickfaw but am looking to expand my areas. I've only been there once or twice and idled pretty much everywhere I went. Thanks ya'll

February 24, 2013 at 4:19pm

So I told my cousin and his friend we were gonna go after a lil catfish. Little did they know we were gonna be after some monsters. They had a great time. We eneded the trip with numerous at 15lbs and one at a whopping 36lbs. Then we had to make them boys clean those cats. Also wanted to show ya'll a new type of gator bait. No stinky smell required. This is not the first one they have 'played with.'

February 04, 2013 at 9:30am

So I was doin some scouting the other day and deer sign was everywhere...everywhere I saw deer tracks there were yote tracks. I have personally seen many and heard them at night. So I'm going to start hunting them to thin them out a lil. Other than mounting one what do most do with them? Let them lie where they fall?

January 28, 2013 at 3:52pm

Wife and I went lookin for a few woodies...Found a few!..

January 05, 2013 at 12:46pm

Well my brother is in on leave from Japan. Not having seen him for a year and a half, we got to make some good memories. Thursday we went and scouted for some fish. Ended up with a few, not to mention about a 2.5lb kicker bass. Then my father, brother and I got to make the bonding trip today. We found a hole of redfish. Must have caught 100 redfish. The fish were so hungry we were even catching them with a just a red 1/4oz jig head(No shrimp/nothing!) We tried to find some trout but didn't want to wonder too far from the boat launch because of the looming rain and eventually ended with a few black drum. All in all we had a great time.

December 29, 2012 at 12:00am

So who's going fishin tomorrow?

December 25, 2012 at 6:54pm

Here ya go givemhell

December 12, 2012 at 7:33am

Goin to bienvenue tomorrow, Not the best day to go but its what I got. See ya'll there!!!

December 10, 2012 at 9:00pm

Hey fellas, Fishing a firemans tournament out of Adams. Ofcourse we can either fish belle river side or spillway side. Anyone been out there lately? Thanks in advance!!

November 06, 2012 at 9:25am

We finally got to make a relaxing trip to the camp on Maurepas since it was flooded from Isaac. No work, just play. Thought I'd run a few jugs and ended up with a nice snapper. How old do ya'll think he is, I tried counting. I'm guessing b/w 25 and 30yrs old? Thought I'd share a couple photos with ya'll!!

October 14, 2012 at 9:54pm

A couple of nice pictures to share.

September 18, 2012 at 10:39pm
A comment titled: Re: Prodrive in response to a report titled: Prodrive

Is the adjusted governor rpm under load at 3800rpms? Are you positive you have the same pitch prop as you had when you purchased the motor? 1' of diameter is a lot to lose i would think.

September 11, 2015 at 12:06pm
A comment titled: Re: boat mechanic in response to a report titled: boat mechanic

What year is the motor. the later year motors were awesome. early fichts were junk. I have an 03 and it runs like a typewrite as long as i gap the plug around every 50hrs. That computer is water cooled and if you ever over heated and kept running it you prob fried the thermocoupling hence. I had a similiar problem. I could start motor and it would run fine until it got warm then would cut off. If i started it and got on it it would stay running because water was being circulated. eventually i fried the computer. If i knew what i know now i would have had it looked at earlier. 1200 for to have computer sent off and and fixed from evinrude. Performance marine works on mine but only if i have to. Long story short take pics and videos of everything before you bring it. the mech ended up breaking my starter housing. he also mounted the motor crooked on the boat and didnt put any zip ties or hose clamps on some of the piping in my motor. There is an evinrude mechanic in prairieville but i can't remember his name. he has a huge shop behind his house. His son is a cert. tech for evinrude.
Since the comp. fix its been a great motor. Good on gas n oil! with my 19ft bass boat loaded it does 60s

February 04, 2015 at 8:13pm
A comment titled: went a couple weeks ago in response to a report titled: Lake Okhissa

Caught a bunch.. only two keepers. Did manage to catch these two slotties on one bait!!

October 01, 2014 at 12:43pm
A comment titled: ... in response to a report titled: Double Banded Pintail

Well I entered it online and I wanna say it took a day for the emailed certificate to come in..

January 15, 2014 at 1:25pm
A comment titled: hmmm in response to a report titled: False River or Old River

Depends on how little they are... probably pretty tough fishin for bass right now. Not sure if two youngin would have fun fishin all day to maybe catch a few if theyre lucky. Prob do just as good anywhere else if the water levels are right. Email me if u have any questions...

January 14, 2014 at 10:37pm
A comment titled: woody in response to a report titled: Double Banded Pintail

I got a band this year and called it in. Duck was from tennessee. Also the emailed me the certificate. After a week or so no mailed certificate so I called back and the lady told me they stopped mailing certificates...

January 14, 2014 at 10:26am
A comment titled: launch in response to a report titled: Manchac Results

U can always use tickfaw public launch...lots of room to park amd free also...

December 16, 2013 at 2:29pm
A comment titled: awesome in response to a report titled: first band

Where did yours come from....I wish I had the money to get mine done..hes in a pot now:(

November 27, 2013 at 10:29pm
A comment titled: thanks in response to a report titled: turkey season

I hope someone would be pretty awesome to have a fresh turkey for thanksgiving...

November 23, 2013 at 9:32am
A comment titled: really in response to a report titled: turkey season

No comments? I'm beginning to think its a dumb question..

November 23, 2013 at 12:20am
A comment titled: no way in response to a report titled: Here's a better angle of LORDBUDS 10lb trout

I dunno the chart says that should be about 17

November 13, 2013 at 2:34pm
A comment titled: hey in response to a report titled: More from today

You don't have to rub it in!

November 12, 2013 at 9:47pm
A comment titled: say what!!!! in response to a report titled: More from today

That as good as it gets!!!!! Looks like a magazine cover to me!!!

November 12, 2013 at 6:59pm
A comment titled: dont let it get to ya!! in response to a report titled: Just WOW

This guy still jealous

November 12, 2013 at 6:57pm
A comment titled: nice in response to a report titled: Just WOW mama always said it don't hurt to ummm where is this shell pad? Haha

November 12, 2013 at 2:05pm
A comment titled: all depends in response to a report titled: Just WOW

The boat next to me caught one that was 26 and an eighth and actually only weighed a lil under 5...looked like it was on a diet...skinny skinny....all in all still trophys iny book. I'm waiting on one over 7 to put on the wall..

November 12, 2013 at 1:38pm
A comment titled: nice job in response to a report titled: Just WOW

While my box shot didnt have the quality u had...we did manage 2 limits with one 5.3 kicker on a digi...measured 25.5 exact... good job...I just need to work on more quality than quantity...

November 11, 2013 at 10:37pm
A comment titled: trailer in response to a report titled: need new boat trailer

Go see mike at mike prices in town...galvenized or aluminum and can customize it to however u want....has the lift to to set boat on trailer and adjust the runners..

November 04, 2013 at 8:07pm
A comment titled: Tips in response to a report titled: hunting maurapaus wma

Bring hip boots/waders...water is up...only ducks around are woodies...hard to huntem when the water is high..dont forget to sign in...make sure you know what is public and what is wma...

October 13, 2013 at 3:03pm
A comment titled: boats in response to a report titled: Cookie jar tournament *EDITED*

Looking like maybe 5..why?

October 10, 2013 at 11:14pm
User has no ads at this time.